Lennox Furnace Repair Nationwide | Dalton Heating & Air Fort Lauderdale

Lennox Furnace Repair in Fort Lauderdale: What to Know First

Lennox furnace repair in Fort Lauderdale typically runs $150–$700 depending on the part and the failure, and our techs can identify the problem on the first visit. Most repairs are completed the same day once the part is in hand. We are an independent Lennox service provider, so we do not answer to a manufacturer’s warranty book when a repair decision gets made. We answer to you, the person who wants an honest diagnosis and a fixed price before anything gets opened up.

Call (754) 354-6972

This page is for Fort Lauderdale homeowners running a Lennox furnace who want to know what actually fails on these units, what a repair should cost, and who is showing up to do the work. Call (754) 354-6972 and a live person answers, day or night.

How Lennox Products Fail — and How We Fix Them

Lennox builds a solid furnace, but certain series have failure patterns that show up year after year in Fort Lauderdale homes. Here’s what we see in the field, not what a brochure says.

• Elite series gas valve sticking. On older Lennox Elite gas furnaces, the gas valve solenoid gets sluggish after years of exposure to South Florida’s salt-laden air, even inside a closet or garage. Symptom: the furnace tries to fire, clicks, then shuts off or runs cold. Our fix is a new OEM or equivalent gas valve, a manifold pressure check, and a written test sequence before we call the job done. This is not a part to clean and hope on.
• Merit series ignitor burnout. The Lennox Merit line uses a silicon nitride hot-surface ignitor, and in Fort Lauderdale’s humid off-season, moisture can sit on the ignitor and shorten its life. Symptom: the blower runs but no flame, or the diagnostic board throws a pressure-switch code when the real culprit is a dead ignitor. We replace the ignitor and check the flame sensor in the same visit, because one usually follows the other.
• Signature series pressure switch nuisance trips. Lennox Signature furnaces with sealed combustion sometimes trip the air-proving pressure switch because the condensate drain line has crudded up, not because the switch itself is bad. Florida bugs and humidity accelerate the gunk. We blow out the line, confirm the draft inducer is pulling correct inches of water column, and only replace the switch if it genuinely failed.
• Heat exchanger cracking on units 18 years and older. This is the one repair where we stop and talk to you before turning a wrench. A cracked heat exchanger on any Lennox furnace, especially pre-2008 models, means carbon monoxide risk. We scope it with a camera, show you the crack, and give you a straight answer: repair if the exchanger is under warranty, or replace if the unit’s age says the money is better spent on new equipment. We will not patch a cracked heat exchanger. Nobody should.
• Blower motor capacitor failure on G-series. Lennox G-series furnaces ran a good blower motor, but the run capacitor is a wear item. In Fort Lauderdale, where furnaces sit idle for long stretches, a capacitor can dry out faster than in colder climates that run heating daily. Symptom: the blower hums but won’t start, or starts slow. We carry a range of OEM-spec capacitors on every truck, so it’s a 30-minute fix rather than a two-trip job.

Our Lennox Furnace Repair Process

Here’s how a Lennox furnace repair works when you call Dalton Heating & Air Fort Lauderdale.

1. 1
   You call, a person answers. We take the symptom from you in plain language, not model-number jargon. Tell us what the furnace is doing or not doing, and we’ll tell you what time we’ll be there.
2. 2
   We arrive inside the window and start with the board. Our tech pulls diagnostic trouble codes from the Lennox control board first, not after guessing. On a Lennox, the board’s error-code history often points to the exact circuit that failed.
3. 3
   We show you the failure before we quote it. We’ll show you the dead ignitor, the stuck gas valve, or the cracked exchanger. Then we give you a written price for the repair before the repair starts, every time.
4. 4
   We explain the parts choice. If the furnace is still under Lennox’s parts warranty, we use the OEM part and charge labor only. If it’s outside warranty, we give you the choice: OEM Lennox part at full cost, or a quality aftermarket equivalent at a lower price. We’ll tell you honestly which jobs deserve the OEM part and which do not.
5. 5
   We fix it, test it, and clean the site. The repair gets a full operational test, including a combustion check on gas units. The work area gets swept and wiped. You leave with a written summary of what was wrong, what we did, and what it cost.
6. 6
   You get the 365-Day Done Right Promise. Every repair is guaranteed in writing for a full year. If the repair fails inside that year, we return at no charge. That is a Garrison Standard term, not an add-on.

What Lennox Furnace Repair Costs in Fort Lauderdale

Most Lennox furnace repairs in Fort Lauderdale land between $150 and $450. The $150 end covers a capacitor, flame sensor, or minor electrical repair. The $450 end covers a gas valve, blower motor, or control board. A full heat exchanger replacement on an out-of-warranty unit can push toward $700, though at that point we’ll tell you plainly if replacement makes more sense.

What moves the price: part availability, whether your unit still carries Lennox parts warranty, and whether we have to pull and reinstall the blower assembly or open the circulating air stream. The diagnostic visit is included when you approve the repair. Call (754) 354-6972 for an exact quote. Estimates are free, and the price is in writing before we start.

Why Fort Lauderdale Homeowners Call Dalton Heating & Air Fort Lauderdale for Lennox Work

Marco Benitez has been running HVAC crews in Fort Lauderdale for over a decade, and his techs have opened Lennox furnaces in everything from Flagler Village condos to single-family homes near Las Olas Boulevard. That means we have seen the exact failure you are dealing with, probably last month, probably on the same model line.

We operate under The Garrison Standard, which has been in place since 2003. The price is written before the work starts. The repair is guaranteed in writing for a full year. The technician who arrives is background-checked, uniformed, and factory-trained beyond Lennox alone, on Carrier, Trane, and seven other major lines. When a Lennox needs a part Fort Lauderdale does not have, we know who does. Our phones are answered by a live person 24/7, not a voicemail queue.

FAQs