Rheem Heat Pump Installation Nationwide | Dalton Heating & Air Fort Lauderdale

Rheem Heat Pump Installation in Fort Lauderdale: What to Know First

Rheem heat pump installation in Fort Lauderdale runs $3,500 to $7,500 for a complete system, and we complete most Rheem changeouts in one day. That’s an honest range for this market – equipment size, duct condition, and whether you need electrical upgrades move the number. Dalton Heating & Air Fort Lauderdale is an independent Rheem service provider, not a factory affiliate. Call (754) 354-6972 for a written quote before any work is scheduled.

Call (754) 354-6972

This page is for Rheem owners in Fort Lauderdale who need a straight answer on installation: how it’s done, what it costs, what fails, and who’s showing up at your door.

How Rheem Products Fail – and How We Fix Them

Every brand fails in its own way. After a decade-plus of pulling Rheem equipment out of Fort Lauderdale closets and side yards, here’s what actually goes wrong and what we do about it:

• RP14 and RP15 series – reversing valve wear in salt air. These are workhorse single-stage heat pumps, but the reversing valve (the part that switches between cooling and heating) is brass-bodied and takes a beating from Fort Lauderdale’s salt-laden air within six or seven years. Burned-out valve coils or a stuck valve body usually show up as a system that cools fine but blows warm air in heat mode. We replace the valve assembly with the OEM part and leak-test the entire line set before recharging.
• RP17 and RP18 series – inverter board failures after power surges. These variable-speed units deliver better humidity control, which matters in Fort Lauderdale, but the inverter boards are sensitive to voltage spikes. After a storm or transformer hit, the unit may run at full speed only or throw a communication error. We diagnose the board specifically before quoting, because replacing an inverter board is a different conversation than replacing a capacitor.
• Corroded coastal coils. The factory evaporator coils on Rheem’s standard line are aluminum fin over copper tube. Within eight to ten years in Fort Lauderdale’s salt and humidity, the fins can corrode enough to lose efficiency and develop leaks. When we’re installing a new Rheem matched system, we recommend the coastal-coated option if the home is within two miles of the ocean. It’s a modest upfront cost that adds real years to the coil.
• Drain pan and condensate line issues from constant humidity. Fort Lauderdale’s wet season means a heat pump’s evaporator coil is constantly producing condensate. Older Rheem air handlers with plastic drain pans crack over time, and algae in the drain line backs up into the pan. We flush lines and check pan slope on every installation. If the pan is cracked on an otherwise-healthy system, that’s a repair – but if the heat pump is nearing the end of its life, we’ll tell you straight that it’s time to run the numbers on a new system.
• OEM vs. aftermarket parts trade-offs. On Rheem units, the compressor and reversing valve always get OEM parts from us. The warranty stays intact and the part matches the system’s engineering. For commodity items like contactors, capacitors, and pressure switches, a quality aftermarket part is often just as reliable and gets the system back online faster. When the part matters for warranty, we use Rheem’s part. When it doesn’t, we explain why we’re using what we’re using.

Our Rheem Heat Pump Installation Process

Here’s how a Rheem heat pump installation goes from first call to final walkthrough:

1. 1
   We answer the phone. A live person takes your call 24/7. You tell us what’s going on, and we schedule a visit inside a two-hour window that same day or next day depending on your need.
2. 2
   We diagnose before we quote. Marco put it simply once: “Tell me the symptom, I’ll tell you the cause – and the price – before anything gets opened up.” We inspect the condenser, check the line set, verify wiring, and run the system’s diagnostics. No price guesswork.
3. 3
   Written price before any work starts. Equipment, labor, duct modifications, thermostat, permits, everything. The number on the quote is the number on the invoice. We’ll also tell you if the system can be repaired for less and what that repair buys you in life expectancy.
4. 4
   Parts and decision. Warranty components come from Rheem. Where a quality aftermarket part is the smarter call, we say so and tell you why. You decide, knowing what you’re paying and why.
5. 5
   Installation with load calculation. We don’t just drop in the same-size unit. We run a Manual J load calculation on every installation, which matters in Fort Lauderdale’s humidity, where oversizing is a comfort and mold problem, not just an efficiency problem.
6. 6
   Test, cleanup, and the 365-Day Done Right Promise. We run the system through its full cycle, check refrigerant charge, measure airflow, and confirm condensate drainage. The site is left clean. The installation is covered in writing for a full year. If it fails during that time, we return at no charge.

What Rheem Heat Pump Installation Costs in Fort Lauderdale

A full Rheem heat pump installation in Fort Lauderdale runs $3,500 to $7,500, and here’s what moves the number:

• Basic 14-15 SEER single-stage Rheem changeout: $3,500 – $4,800. Existing ductwork and electrical are compatible.
• 16-17 SEER two-stage or variable-speed Rheem system: $5,200 – $6,900. Better humidity control, which many Fort Lauderdale homes benefit from for half the year.
• Full system with duct replacement or significant electrical work: $7,000 – $7,500 when the existing ducts are compromised or the panel needs upgrading.

The honest variables are home size, ductwork condition, panel capacity, and whether you want coastal-coated coils. We’ll give you a written price before anything starts, and estimates are free. Call (754) 354-6972 to schedule one.

Why Fort Lauderdale Homeowners Call Dalton Heating & Air Fort Lauderdale for Rheem Work

Florida’s heat pump market is full of companies that’ll throw a number at you over the phone and then change it on the driveway. We don’t work that way. Every job gets a written price before any work begins, a written guarantee on every repair, and a free second visit if the repair fails. That’s The Garrison Standard, and it’s been the rule since 2003.

Our techs know Rheem’s quirks because we’ve worked on enough of them across Fort Lauderdale, from older split systems in Flagler Village to variable-speed units near Las Olas Boulevard. And if a Rheem just isn’t the right fit for the home, we service Carrier, Trane, and Lennox too, so you’re getting an honest recommendation, not a brand pitch. Calls are answered by a real person around the clock.

FAQs