Furnace & heating
AC repair
Heat pumps
Ductless mini splits
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateFast, Reliable Furnace Repair Across Fort Lauderdale
Most furnace repairs in Fort Lauderdale run between $150 and $700 depending on the failed part, and the typical job is done in a single visit. That said, Fort Lauderdale homes throw specific problems at furnaces that you won’t see inland: salt air eating at heat exchangers, attic ducts sweating from humidity, and storm surges frying control boards. If your furnace is acting up, call Dalton Heating & Air at (754) 354-6972. We answer live, 24/7, and we’ll have a background-checked technician at your door inside the window we give you.
The price you’re quoted is the price you pay. It’s in writing before any work starts. No markup at the door, no “while we’re here” add-ons. That’s how we’ve operated under The Garrison Standard since 2003, and it applies to every Furnace Repair call we run in Fort Lauderdale.
Why Dalton Heating & Air Fort Lauderdale Is Fort Lauderdale’s Preferred Furnace Repair Company
Fort Lauderdale homeowners don’t need another company that promises a lot and shows up whenever. They need a crew that knows the difference between a 1962 ranch in Rio Vista and a mid-rise condo off Galt Ocean Drive. We’ve worked both. We know that original ductwork in unconditioned attics sweats in our humidity. We know rooftop package units on Las Olas Isles bake in the sun and eat capacitors. This is the local knowledge that turns a two-hour diagnostic into a 20-minute one.
Every Dalton Heating & Air technician arrives in uniform, background-checked, and factory-trained on nine major residential brands. We service Carrier, Trane, Lennox, American Standard, and more. And every repair, no exceptions, carries a written guarantee for a full year. If it fails in that year, we come back free. That’s our 365-Day Done Right Promise, and it’s the same promise we’ve made since 2003 as a Garrison Partners company.
Marco Benitez, who leads our Fort Lauderdale operation, tells our techs the same thing on day one: “Put the price in writing, do the job by the book, and leave the site cleaner than you found it.” That’s The Garrison Code. It’s not a slogan. It’s the standard.
Styles & brands we work with
Gas Furnace Repair in Fort Lauderdale
Gas Furnace Repair in Fort Lauderdale usually means tracking down a failed ignitor, a corroded heat exchanger, or a gas valve that won’t open, and the fix lands between $150 and $700 depending on the part. Older homes here, especially 1950s-to-1970s ranches and the sprawling homes in neighborhoods like Rio Vista and Coral Ridge, have furnaces that fight two enemies: salt air and humidity. Salt gets pulled in through original ductwork and settles on the heat exchanger. Humidity keeps the metal damp. Rust follows. The repair is rarely just a part swap; a good tech looks at why the part failed and whether the ductwork feeding it is making it worse.
Heat Exchanger and Gas Valve Diagnosis
When a heat exchanger cracks or corrodes, the furnace can leak carbon monoxide into the house. That’s a job for a trained professional. We test with a combustion analyzer, inspect the full exchanger, and quote the replacement in writing before we touch it. Gas valve failures show up as a furnace that won’t fire or fires intermittently, and a proper repair includes checking gas pressure at the manifold.
Ignitor and Control Board Replacement
Fort Lauderdale’s afternoon thunderstorms do real damage to furnaces. A power surge will take out a control board or a hot surface ignitor without warning. Older homes without whole-house surge protection see this most often. We keep common ignitors and boards on the truck, which means one trip instead of two for a lot of our Fort Lauderdale customers.
Furnace Tune Up in Fort Lauderdale
A Furnace Tune Up in Fort Lauderdale runs $80 to $200 and is the cheapest insurance you’ll buy for a system that sits idle most of the year and then has to run hard on the few cold snaps we get in January and February. Our tune-up is a written 20-point inspection: we test the heat exchanger, check the ignitor, measure the gas pressure, clean the flame sensor, check the blower motor, and inspect the duct connections. We give you a written report of what we found, with photos, and a quote for anything that needs to be addressed. Nothing gets fixed without your written approval.
Duct Inspection in Unconditioned Attics
Most Fort Lauderdale homes built before 1980 have ductwork in unconditioned attics. High humidity causes sweating, mold growth, and air leaks that quietly cut airflow by 30 percent or more. Our tune-up includes a visual duct inspection. If your ducts are sweating or leaking, we’ll tell you exactly what it’ll cost to seal and insulate them. We don’t touch anything without a written price first.
Aging Electrical Panel Check
Modern furnaces with ECM blower motors pull a startup load that old panels can’t always handle. During a tune-up, our techs check the circuit, the breaker, and the wiring connections. If your 1960s panel is struggling to feed a modern furnace, you’ll know before it fails on the coldest night of the year.
Trusted Brands We Service in Fort Lauderdale
We’re factory-trained on nine major residential brands, including Carrier, Trane, Lennox, and American Standard. That matters because a Carrier heat exchanger and a Trane control board don’t diagnose the same way, and a tech who’s guessing wastes your time and your money. We also stock common parts for these brands in our local Fort Lauderdale trucks, so a lot of repairs happen same-visit. If we have to order a part, we’ll tell you exactly when it lands and exactly what the total will be before you agree to anything.
Common Furnace Repair Problems We See in Fort Lauderdale Homes
- Salt-corroded heat exchangers: Homes on the barrier island and along the Intracoastal Waterway pull salt-laden air through original ductwork, and that salt settles inside the furnace, rusting the heat exchanger years before it should fail. We see this in Victoria Park, Las Olas Isles, and River Oaks.
- Sweating attic ducts: Original ductwork in unconditioned attics collects condensation in our humidity, which leads to mold, reduced airflow, and a furnace that works harder than it should. Sealing and insulating the ducts is often the real fix.
- Storm-surge control board failures: Afternoon thunderstorms roll through Broward County almost daily in summer, and a close strike or grid surge will take out a furnace control board or capacitor. Homes without whole-house surge protection are the most likely to call us the day after a storm.
- Tired electrical panels: Homes built in the 1950s through the 1970s often have panels that can’t handle a modern furnace’s startup load. The symptom is a breaker that trips when the heat kicks on or a blower motor that hums but won’t start.
See the difference
Before
After
Before
After
Before
AfterPricing for Furnace Repair in Fort Lauderdale, FL
Here’s what you can expect to pay in Fort Lauderdale. These are the written ranges we give over the phone, and the price we quote before work begins is the price you’ll see on the invoice.
| Service | Typical Cost |
|---|---|
| Gas Furnace Repair | $150 – $700 |
| Furnace Tune Up | $80 – $200 |
What moves a repair from the low end to the high end is the failed part. An ignitor is cheap; a heat exchanger or blower motor is not. The labor and the written guarantee are the same either way. Every repair includes a full-year written guarantee, and if the work fails in that year, we come back at no charge. Estimates are free. Call (754) 354-6972 and we’ll give you a straight answer about cost before we send anyone to your door.
We Also Serve Cities Near Fort Lauderdale
Our service area covers Fort Lauderdale and the surrounding Broward County communities. You’ll see our trucks in Plantation, Pompano Beach, and Margate nearly every day of the week. If you’re in one of those cities, we run the same schedule and the same guarantee as we do inside Fort Lauderdale proper. Learn more about our full Fort Lauderdale coverage and what to expect on your first visit.
The Fort Lauderdale Difference: Salt Air, Old Homes, and Ducts That Sweat
Fort Lauderdale is not Miami, and it’s not Plantation. Our barrier island and Intracoastal Waterway homes, the ones in Rio Vista, Las Olas Isles, and along the waterways of Coral Ridge, live in salt-laden air that never quits. That salt gets drawn into the furnace through leaky return ducts, coats the heat exchanger, and holds moisture against the metal. The result is rust, pitting, and eventually a cracked exchanger. Inland Broward homes don’t deal with this the same way. A furnace that lasts 20 years in Margate might need a heat exchanger at 12 years on Isle of Venice Drive. We’ve seen it enough times that corrosion-resistant coatings and more frequent coil cleanings are standard recommendations for our coastal Fort Lauderdale customers.
And then there’s the age of our housing stock. Fort Lauderdale is dominated by 1950s-to-1970s single-family ranches and mid-rise condos, most of which still run their original ductwork through unconditioned attics. In our humidity, that ductwork sweats. The insulation gets wet, the joints separate, and the system loses air before it ever reaches the bedrooms. A like-for-like furnace swap in one of these homes doesn’t fix the problem; it just puts a new furnace on top of the same leaky distribution. That’s why we check static pressure and duct condition before we recommend any repair or replacement.
In a 1960s ranch in Rio Vista, our tech found a Carrier furnace with a corroded heat exchanger from years of salt air intrusion through the original ductwork. We replaced the heat exchanger, sealed and insulated the ducts in the unconditioned attic to stop the sweating, and verified static pressure dropped to design specs. The furnace ran fine. The real fix was the distribution.
Serving Fort Lauderdale, FL - Our Local Coverage Area
We’re based in the Fort Lauderdale area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Furnace Repair in Fort Lauderdale
Salt-laden air from the Atlantic and the Intracoastal Waterway gets pulled into your furnace through leaky return ducts, and salt holds moisture against the metal. That combination rusts a heat exchanger years earlier than a furnace in Plantation or Margate would see. The fix is often a corrosion-resistant coating and sealing the ducts so less salt gets in. Call (754) 354-6972 and we’ll inspect your exchanger and quote the repair in writing.
You can, but you’ll likely end up with the same comfort problems you already have. Most 1960s Fort Lauderdale ranches have leaky original ducts in unconditioned attics, and putting a new furnace on leaking ducts wastes 20 to 30 percent of your airflow. We’ll measure static pressure and duct leakage before we quote anything, so you know what the real fix costs.
That’s usually a failed capacitor or a control board damaged by a power surge from one of our afternoon thunderstorms. Older Fort Lauderdale homes without whole-house surge protection take the worst of it. We keep capacitors and common boards on the truck, so this is often a single-visit repair. Call us at (754) 354-6972 and we’ll give you a written quote before we start.
Yes, and it’s the Florida sun. Rooftop package units with no shade get direct sun all day, and the heat breaks down capacitors and shortens compressor life. We keep extra capacitors on every truck serving Las Olas Isles and the beach side of Fort Lauderdale. If your rooftop unit won’t start, call us before you call anyone else.
Your attic is unconditioned and humid, and the cold metal cabinet is condensing water out of the air. That’s a red flag for air leaks and missing insulation, and it leads to mold and rust. The fix is sealing and insulating the furnace cabinet and the ducts feeding it. We’ll quote that work in writing so you know the exact price before we begin.
Call Dalton Heating & Air for Furnace Repair in Fort Lauderdale
If your furnace is down or just making a noise it shouldn’t, call (754) 354-6972 right now. A live person answers 24/7. We’ll put a time on the calendar that we actually keep, send a background-checked tech in a Dalton uniform, and put the price in writing before any work begins. Every repair is guaranteed in writing for a full year. If it fails in that year, we return at no charge. That’s the deal. It’s been the deal since 2003.
Written by Marco Benitez, Owner at Dalton Heating & Air Fort Lauderdale, serving Fort Lauderdale and surrounding Broward County.